We have developed Chip dryer "Yamato" series, which uses superheated steam to more efficiently dry (degrease) cutting oil adhering to metal chips more safely than with conventional methods. (Patented)
Most conventional technologies are kiln-type, which use hot air, but they also generate a lot of dust, and because they use fire, there is a risk of explosions and fires. The newly developed chip dryer "Yamato" uses superheated steam, so no flames or explosions occur inside the main unit, and the dried gas is immediately cooled with water, so no dust is generated. This makes it an extremely secure system. Another big advantage of aluminum chips is that the most dangerous dust can be safely collected during cooling, eliminating the need for a dust collector.
Of course, the ability to remove adhering oil has also been improved compared to conventional drying methods, so even if the chips are put into the melting furnace after drying, very little dust or smoke is generated, making them safer and more environmentally friendly. This is a chip dryer that has made great progress.
Please feel free to contact us so that we can provide you with information about our past achievements and data.

Materials with high moisture content and difficult to dry, such as okara, used tea leaves, coffee grounds, waste bacteria beds, sludge, and sawdust, can be dried to a moisture content of 10% or less in a short time and with high efficiency, and running costs are reduced. Turbulence dry & Tornado separator "FU-JIN" series also contributes to the compression of air.
Using three unique technologies: hot air, ceramic balls, and far-infrared rays, it has become possible to achieve highly efficient drying with running costs about 1/3 to 1/5 compared to conventional kiln-type dryers.We hope you will see for yourself the amazing drying ability that dries in just a few seconds. Test drying is also available at Shinkiba's Tokyo office from time to time, so please see "Turbulence dry & Tornado separator official website" for details. Please take a look.
In particular, if you are having trouble with waste mushroom beds or factory sludge, please consider drying it and using it as fuel for your company.

In aluminum die-casting machines that manufacture automobile parts, etc., the chip lubricating oil used burns and spreads in the factory as soot and oil mist, causing problems such as environmental problems, health hazards, dirt in the factory, and safety. It has become. In particular, the soot and oil mist generated by combustion were a major problem, but there was no device that could collect them at the same time, and the only solution was to take countermeasures such as periodic cleaning of dirt.
Therefore, we have developed a device that can simultaneously collect soot and oil mist for a long period of time using our own technology, and have completed the soot and oil mist removal device "TENRYU" series.(Patented)
Currently, our machine is used by a major automobile parts processing manufacturer that uses aluminum die-casting machines, but if you are having the same problem, please contact us.
In addition, for those who have trouble with oil mist that occurs over a wide area, we recommend the soot and oil mist removal device "TENRYU", which requires almost no maintenance. We look forward to hearing from customers who are considering improving their workplace environment by eliminating oil mist smog floating in their factories.